5.8G Band Pass Filter UWB Wideband Filter with SMA Interface for Wireless System FBP5060

Feature: 1. [FOR 5.8GHZ RECEIVER] This filter has low in band insertion loss, with steep cut off characteristics, is dedicated to 5.8GHz receiving device. 2. [HIGH EFFICIENCY] The bandpass filter can effectively filter out of band signals, reduce noise and increase dynamic range. 3. [GOOD SUPPRESSION] Good suppression of out of band remote signals, better than products made with PCB bare boards. 4. [ALUMINUM ALLOY] Using aluminum alloy shielded shell, has less interference and no out of band spurious response. 5. [SMA INTERFACE] The bandpass filter interface is SMA?M and SMA?F, both ends are symmetrical and there is no directionality. Specification: Item Type: Band Pass Filter Material: Aluminum Alloy Model: FBP5060Impedance: 50 Ohm Center Frequency: 5500MHz 3dB Passband: 49006100 MHz Insertion Loss: <2.5 dB at 51005900 MHz Maximum Carrying Power: 5W (37dBm) at 1 minute Interface: SMAM, SMAF (RF characteristics are symmetrical at both ends, no directionality). Package List: 1 x Band Pass Filter Note: Do not overload to use.[FOR 5.8GHZ RECEIVER] This filter has low in band insertion loss, with steep cut off characteristics, is dedicated to 5.8GHz receiving device. [HIGH EFFICIENCY] The bandpass filter can effectively filter out of band signals, reduce noise and increase dynamic range. [GOOD SUPPRESSION] Good suppression of out of band remote signals, better than products made with PCB bare boards. [ALUMINUM ALLOY] Using aluminum alloy shielded shell, has less interference and no out of band spurious response. [SMA INTERFACE] The bandpass filter interface is SMA?M and SMA?F, both ends are symmetrical and there is no directionality.