Effector Foot Switch Hat Switch Cap Foot Cover Aluminum [F.S.T.A.] (Purple)

---------------------------------------------------------------------- 【JOOM Approved! Sold & Shipped by Trusted Japanese Sellers】

🔹 Operated by Verified Japanese Sellers – Approved by JOOM, our experienced Japanese sellers provide reliable service. 🔹 Direct Shipping from Japan – Carefully packed and promptly shipped straight from Japan. 🔹 Japanese-Standard Quality Control – Strict inspections ensure only high-quality products reach you. 🔹 About Included Manuals – If a manual is included, it will primarily be in Japanese. ---------------------------------------------------------------------- Foot Switch Top Armor is a foot switch cap that can be attached to a foot switch to make it easier to press the effector switch. The high-class finish that looks like machined aluminum and the bright alumite color improve the visibility of the switch. Also, since the treadle itself is larger, switching mistakes can be prevented. Unlike cheap products that tighten the switch directly with set screws, the use of hard rubber inside improves the fit to the switch part. In addition, it can be installed and removed without damaging the switch itself. You can use it just by covering it with a standard 10mm diameter foot switch, but for smaller diameter ones or to securely install the product, a 1.5mm hex wrench is required. Many people probably own a 1.5mm wrench, as it is the same size as the one used for adjusting the bridge of Strats and hardtails. 1 piece Size: Outer diameter 23mm Inner diameter 10mm Height 10mm Material: Aluminum Foot Switch Top Armor is a foot switch cap that can be attached to a foot switch to make it easier to press the effector switch. The high-class finish that looks like machined aluminum and the bright alumite color improve the visibility of the switch. Also, since the treadle itself is larger, switching mistakes can be prevented. It is often used as a main distortion effect such as overdrive/distortion. It is also useful to separate colors for each channel of the switcher to make it easier to understand. Unlike cheap products that tighten the switch directly with set screws, the use of hard rubber inside improves the fit to the switch part. In addition, it can be installed and removed without damaging the switch itself. You can use it just by covering it with a standard 10mm diameter foot switch, but for smaller diameter ones or to securely install the product, a 1.5mm hex wrench is required. Many people probably own a 1.5mm wrench, as it is the same size as the one used for adjusting the bridge of Strats and hardtails. Size: Outer diameter 23mm Inner diameter 10mm Height 10mm Material: Aluminum *For special usage, it is also possible to accommodate special sized foot switches up to 14mm in diameter by removing the internal hard rubber.