The high-pressure oil pump plunger for EA113 engine modification with the pump core diameter increased to 9.5mm
Attention
In order to avid unnecessary trouble between us,please confirm the item must fits your car when you are purchasing! If you're not sure,please tell me the part number or send me some pictures,thanks!
Qty:one set (as the picture shown)
Part Number:06F127025H 06F127025B 06F127025L 06F127025M
Fit for EA113 enlarged pump core with a diameter of 9.5mm
For Volkswagen, , 2.0T,
For Golf R20,
Installation manual for high-pressure pump enlarged pump core
1: Install the enlarged pump core using a special tool combined with a torque wrench to torque 50-60Nm. If it is too tight, it will get stuck, and if it is too loose, it will leak internally.
2: Before installing the oil pump, take out the top cup with Needle-nose pliers to check whether it is damaged. If it is damaged, replace it.
3: Apply clean engine oil to lubricate the O-ring and install it (be careful not to miss the top cup)
4: Tighten the mounting bracket screws (20N. m) crosswise with a wrench, and then tighten the other joints in sequence
5: After installation, start the engine and run it at idle speed for 3-5 minutes. Observe whether there is any oil leakage or abnormal noise at the connection of the high-pressure pump. Use a computer to read the parameters of the high-pressure pump and check the data flow
6: Increase the speed of the pump core after testing and control it to within 4000 rpm, allowing the pump core to run in for 100-200 miles
No-delivery refund
