These are genuine replacement wheels for Rippa Skate.
What you need for replacement
Two 5mm hex wrenches
How to replace
1: Insert the hex wrenches into the grooves on the left and right sides of the shaft.
2: Hold the wrench in your left hand and turn the shaft by pulling the wrench inward with the wrench in your right hand.
The shaft is quite tight, so some force will be required.
3: Remove the short shaft (male end) and the long shaft (female end).
4: Replace the wheels.
Threading the shaft (female end) can be tricky.
If you have trouble threading the shaft through,
use the wrench to secure the spacer between the bearings.
5: While holding the shaft in place with the wrench in your left hand,
use the wrench in your right hand to tighten the shaft while adjusting it.
Be careful not to overtighten the shaft.
The trick is to tighten it just enough so it doesn't loosen.
6: Gently turn the wheel by hand; if it turns smoothly, the replacement is complete.
Product Specifications
●64mm Wheels
●2-piece Set
*A 5mm hex wrench is required for replacement.
Hex wrench not included.
(From Amazon.co.jp)
Includes two genuine replacement wheels for Rip Skate.
Create your own custom caster board by swapping them out!
Replace the wheels when they become worn and difficult to slide.
Rolling power is determined by the balance of multiple factors, including the momentum of swinging the board left and right, gravity, and centrifugal force.
A 5mm hex wrench is required for replacement.
החזר על אי אספקה
