RC Motor Gear Puller Stainless Steel Gear Removal Tool Motor Sprocket Remover Tool For Car Repairing Accessories

Hign-concerned Chemical : None Origin : Mainland China dropshipping : support

RC Motor Gear Puller Stainless Steel Gear Removal Tool Motor Sprocket Remover Tool For Car Repairing Accessories

Bullet Points: 1、[ Easy to Use ] RC Motor Gear Puller needs to pull the thimble during use, connected to the rotating rod and tightened the screw, very convenient and light. 2、[ Wide Range of Application ] The good Gear Puller is suitable for remote control cars, compatible with HSP HPI RC4WD AXIAL SCX10, a good sprocket remover. 3、[ Top Quality Materials ] Motor Gear Puller Remover Tools Set is made of high-quality stainless steel, heat-resistant and corrosion-resistant, with good physical luster, and sturdy and durable for long-term use. 4、[ Excellent Craftsmanship ] Gear Remover is with CN-C precision machining, with high repeat machining accuracy, especially some complex shapes that are difficult to process by hand, the surfaces of the scraper is bright and burr-free, smooth, and thorn-free. 5、[ Portable Design ] Motor Gear Remover is small in size and lightweight, easy to carry and easy to use, and can be placed in a backpack without taking up space. Specification: Name: Motor sprocket remover Size: about 6 x 5 x 2cm/2.36*1.96*0.78inch Weight: about 63g Material: aluminum alloy How to use the gear puller: 1) Please select the needle according to the thickness of the motor shaft diameter. Do not use a needle that is too small to push the motor with a large shaft diameter to extract teeth, otherwise the ejector pin will be broken. The glued gear should be heated first to melt the glue. Extraction again! ! 2). Select the thimble of the gear puller you need, install it into the rotating rod of the gear puller, and tighten the screws (note: for the thimble with a platform, the screw should not be too tight). 3). Install the broaching rod into the broaching bracket. 4). Install the floating plate of the gear puller. 5). Snap the motor into the broaching plate, and move until the motor shaft aligns with the broaching thimble. 6). Rotate the lever of the gear puller clockwise at a constant speed to pull out the motor gear. 7) It can pull gears with a maximum outer diameter of 11mm and a tooth height of less than 12mm Packing List: Motor sprocket remover*1 pcs Notes: 1. Due to the lighting effects and angles, there is a color difference in the product, please understand. 2. Due to manual measurement, there is a tolerance in the product size.