Description:
- PWM-to-voltage module can convert the digital PWM signal 0%-100% into an analog signal 0 ~ 10V.
- Can be used for industrial control panel or other signal interface switching, by adjusting the PWM duty cycle to regulate the output voltage.
- Adopts embedded microcontroller technology, easy to operate, you can fine-tune it through the potentiometer.
- Further increases the output voltage accuracy to within 1%, the input frequency is increased to 3KHZ, support PWM, duty cycle to voltage (via short resistor) and 5V/10V selection (via short resistor).
Specification:
- Size: Approx. 33.14 x 33.02 mm/1.304 x 1.3 inches
- 5/10 short D/F open 1-1KHz frequency to 0-5V (duty cycle at will)
- 5/10 open D/F open 1-1KHz frequency to 0-10V (duty cycle at will)
- 5/10 short D/F short 0-100% duty cycle to 0-5V (frequency range 1Hz-3KHz)
- 5/10 open D/F short 0-100% duty cycle to 0-10V (frequency range 1Hz-3KHz)
- Supply voltage: 9V ~ 24V
- Signal input frequency range: 1Hz ~ 3KHz (amplitude 3.3V-5V)
- Signal input duty cycle range: 0 ~ 100% (amplitude 3.3V-5V)
- Output voltage: 0.00V ~ 5.00V/0.00V ~ 10.00V
- Error Tolerance: within 1%, linear conversion
- Wiring definition:
- 12V: Positive power connector (9V to 24V)
- GND: Power ground interface
- PWM: signal input (1-1KHz 0-100%) (amplitude 3.3V-5V)
- GND: signal input negative interface or ground
- OUT: Signal output interface (0.00V to 5.00V/0.00V to 10.00V)
- GND: Ground interface
Note: When the output is from 0.00V to 10.00V, the power supply voltage must be more than 10 volts.
Package Includes:
1 Piece PWM to Voltage Converter Module
החזר על אי אספקה
