High pressure oil pump plunger modification with an increased diameter of 11.6mm, suitable for 3rd generation EA888 2.0
Attention
In order to avid unnecessary trouble between us,please confirm the item must fits your car when you are purchasing! If you're not sure,please tell me the part number or send me some pictures,thanks!
Condition:new
Part Number:06L127025K 06L127025J 06L127026D 06L127025P
Qty:one set (as the picture shown)
Pump core diameter 11.6MM
Suitable for EA888 three-generation 2.0T Hitachi pump
Installation manual for high-pressure pump enlarged pump core
1: Install the enlarged pump core using a special tool combined with a torque wrench to torque 50-60Nm. If it is too tight, it will get stuck, and if it is too loose, it will leak internally.
2: Before installing the oil pump, take out the top cup with Needle-nose pliers to check whether it is damaged. If it is damaged, replace it.
3: Apply clean engine oil to lubricate the O-ring and install it (be careful not to miss the top cup)
4: Tighten the mounting bracket screws (20N. m) crosswise with a wrench, and then tighten the other joints in sequence
5: After installation, start the engine and run it at idle speed for 3-5 minutes. Observe whether there is any oil leakage or abnormal noise at the connection of the high-pressure pump. Use a computer to read the parameters of the high-pressure pump and check the data flow
6: Increase the speed of the pump core after testing and control it to within 4000 rpm, allowing the pump core to run in for 100-200 miles
החזר על אי אספקה
