Tuningfan Shift Pattern Lower Right for Manual Transmission Emblem, Red, R, 6-Speed Vehicles, SPE-R602






תיאור
Tuningfan Shift Pattern Emblem - RED (Red) - Lower Right Reverse - For 6MT Vehicles Hairline base finish + clear dome processing. Size: 16mm (height) x 22mm (width) x approximately 2mm (thickness) Made with non-yellowing polyurethane resin. Adhesive: Strong adhesive. Made in Japan. Tuningfan Original Product: Shift Pattern Emblem - RED (Red) - For 6MT Vehicles Part number: SPE-R602 A red shift pattern emblem, a highly requested item, is now available. It's a perfect match for the red-stitched interior! Using a dome made of highly transparent polyurethane resin It combines a three-dimensional, beautiful gloss with high durability thanks to UV protection. Upgrade your interior with a luxurious finish unlike typical stickers! This applies to all 6-speed manual transmission vehicles with the same pattern as indicated. It can be installed simply by attaching it to the side of the shift boot or the shift panel. The dimensions are 16mm (height) x 22mm (width) x approximately 2mm (thickness). To ensure it can be applied anywhere, it is made to almost the same dimensions as the original shift pattern labels from car manufacturers. A simple and timeless design that eliminates unnecessary logos and decorations. Tuningfan Original Product By applying red to a metal hairline base, It has a texture similar to anodized aluminum, where the color appears different depending on the viewing angle. To match the red stitching on the shift boot and seats, a slightly darker red was chosen. Examples include the 86/BRZ, ZC32S/ZC33S Swift Sport, ND5RC Roadster, and VAB WRX STI. It also goes well with the interior of a sports car with red stitching. *Shift knobs without a shift pattern printed on them will not pass vehicle inspection. For driving on public roads, the installation of a shift pattern plate like this is mandatory. Recommended for those with aftermarket shift knobs that do not have a pattern plate installed. The adhesive in this product is made from the strongest possible material, If there is dust or oil on the surface to which you are applying the sticker, the adhesive strength will inevitably decrease significantly. If a polishing agent or similar has been applied, Please remove any residue thoroughly using a parts cleaner or alcohol wipe before applying. After peeling it off the separator (backing), carefully stick it on, making sure not to touch the adhesive surface. Apply pressure to the entire surface and press firmly to ensure a tight fit. It can take up to 24 hours for the adhesive to stabilize after initial adhesion. Please avoid moving or repositioning it. If the temperature is below 10 degrees Celsius, it will be difficult to apply, so use a hairdryer or similar device. Please warm it slightly before applying. Flat/gently curved surfaces made of common plastics (PE, PP) This product is designed to be attached to interior panels. For application to rough surfaces such as textured surfaces, curved surfaces, and soft-touch painted surfaces: Please use the included double-sided tape (JIS "Super Strong" tape, manufactured by 3M). Dome section: Polyurethane resin (non-yellowing) Pattern markings: Hairline laser printing Adhesive: Strong adhesive


























